Penetration seal and ink printing method: The penetrating seal type atomic ink printing surface is prominent, and the surface atomization and penetration printing can be distinguished to directly observe the surface. When adding ink to the penetrating seal, a small amount of ink can be dropped on the surface. It is not advisable to add too much at a time. It is best to use the same brand of original ink. Otherwise, the ink may not be used properly, resulting in the internal pores of the seal being tight and not being printed. The solution is ominous, because the seal is printed in the ink after the seal is made, so it is more difficult to deal with.

 

The first step: open the stamp bottom cover　　

　　　　

Step 2: Add ink to the text of the seal

 

Step 3: Put the seal upside down and wait for the ink to penetrate

 

Step 4: After the ink is completely infiltrated, it can be stamped directly

 

 

　　

Ink seal printing method: ink stamp, there is a built-in stamp in the rack, just press the stamp down about 3 mm to push the built-in stamp, you can drop the ink on the surface of the stamp, no need to print too much oil, just right, run out Plus. The ink returned to the ink is absorbed very quickly, and it is almost infiltrated as soon as one side is added. The same method puts the stamp down about three millimeters to put the stamp back. If you add the wrong ink, you can use a lot of water to clean, you can also add a gentle hand sanitizer to gently press. Wash all the ink and dry it with a paper towel. Note that the surface of the pad is very delicate, so do not damage it, so that the pad can continue to be used but the life is not long. It is recommended to purchase special ink when ordering the seal to avoid unnecessary trouble!

 

The first step: press the button

 

Step 2: Remove the stamp pad

 

Step 3: Add ink to the printing pad

 

Step 4: Put the stamp pad back in place

 

Step 5: You can stamp directly on the printing pad.